Designed primarily for yeast and Gram-positive bacteria, the AutoXT CLiNiC-Q multi DNA Kit is an automated nucleic acid extraction technique that is suitable for food microbiology research and infectious disease diagnostics. It provides high-purity, high-concentration nucleic acid extractions using a magnetic bead technique, and because of its bead-based physical pretreatment, it works particularly effectively for processing viscous samples or tissues. This kit allows for quick DNA extraction, completing the procedure in less than 20 minutes, and it requires only minimal setup to process up to 32 samples at once. It consistently recovers entire DNA from a range of difficult materials, such as those with high viscosity or thick cell walls. It is compatible with established licensed diagnostic techniques and exhibits greater extraction efficiency when compared to other products.
Research/Application area
- Pathogen Detection Analysis
- Infectious Disease Research
- Genotyping
AutoXT CLiNiC-Q multi DNA Kit
Individual Type (48T) Well-plate Type (96T) Prefilled Individual plates Prefilled Well plates 12 Plunger tips 12 Plunger tips Proteinase K and RNase A
(Lyophilized) (1 ea)
Proteinase K and RNase A
(Lyophilized) (2ea)
Cartridge Rack (2 ea)
Q : DNA extraction yield is lower than expected. What should I do?
A : It is believed that the homogenization of the sample was not performed properly. Check the extraction protocol setting of the Miracle-AutoXT Nucleic Acid Extraction System equipment to make sure it is considered suitable for the extraction target. Before using the equipment, check the rack fixing status of the cartridge and the set temperature of the block (need to set the proper temperature) before proceeding.
Q : After the extraction experiment, PCR & Real-time PCR results are not confirmed.
A : First, please check whether there are any problems with the sample preparation process. Check the sample preparation in the user manual and use the recommended sample amount. Second, please check whether the protocol of the product and equipment is proceeding normally. This product is optimized for Bacteria fast protocol.
Q : After the extraction experiment, a signal was detected in the NC (negative control) during qualitative analysis.
A : First, non-specific reactions may occur due to environmental factors, so please cleanly disinfect the equipment and test table you are using before proceeding. Second, to minimize contamination of cartridges adjacent to the product, avoid splashing when loading the sample. The plunger tip provided in the product is for one-time use, so to prevent sample contamination, use a new tip for each experiment and do not use it repeatedly.
Q : RNase A and Proteinase K included in the product are in powder form. How do I use it?
A : RNase A and Proteinase K of this product are supplied as “Lyophilized”, and you can use it by dissolving it in pure D.W according to the amount written on the bottle and tube. After thawing, you can freeze it (-20℃) after use.
